HORN SWITCH UPGRADE
Installation Guide
WARNING! Verify that there is clearance behind dash for switch. Using the switch mount as a template, mark, drill and cut out rectangle. Install switch mount. Run switch wires through housing and attach. Insert switch into mount.
Using the housing as a template mark the rectangle.
Drill a hole in each corner
Using a cutting tool cut out the rectangle
Trim as needed
Insert the housing
Run wire through housing and attach to switch
Insert switch into housing
Please visit our website at www.xtcpowerproducts.com
For support on installation we can be emailed at support@xtcpowerproducts.com or we can be reached by phone at 480-558-8588.
XTC Power Products
A Division of XTC Motorsports LLC
925 N McQueen RD. #101
Gilbert AZ 85233
480-558-8588
Copyright © 2015 XTC MOTORSPORTS LLC All Rights Reserved