RZR
Fan Override Switch with Power Relay
Thank
you for purchasing our Fan Override Switch. This kit was designed so that you can
override the engine cooling fan keeping your engine running cooler.
Please read the instructions fully and familiarize yourself with the components
before starting the install.
-
Remove Hood
-
Mount the relay on the fire wall with the supplied screw, Polaris offers 4
spots on the fire wall for this purpose
-
Un-plug the connector in front of the fan and plug our adapter in to both
sides, male and female.
-
Remove the switch from the cable and run up to dash.
-
Using the switch mount as a template cut the dash for the switch. Make sure
there is room behind the dash for the switch. See Horn Switch installation
guide for more instructions.
-
Run the wires through the hole and plug the black wire to the top right
terminal, the red wire to the middle terminal and the blue wire to the
bottom terminal and push switch into dash
-
Attach the wire with the fuse on it to the factory post marked battery , if
you have not yet run power to that post then you need to do so, the factory
provided accessory switched post
only offers low power.
XTC offers a RZR Power Up cable system with Circuit Breaker # RZR- PWR-UP2
for 2 seat and RZR-PWR-UP4 for
4 Seat for this purpose.
-
Verify operation.
WARNING! The cooling fan is high current and if left turned on it will kill your
battery.
XTC Power Products
A
Division of
XTC Motorsports LLC
925 N McQueen RD. #101
Gilbert AZ 85233
480-558-8588
www.xtcpowerproducts.com
Copyright 2015 © XTC Motorsports LLC, All Rights Reserved