Thank you for purchasing XTC Motorsports RZR High Beam Activation Power
Relay . No need to add a switch on the dash, this system uses your high beam
to activate extra lights.
Please read the instructions fully and familiarize yourself with the components before starting the install. Quick Install Guide.\
Mount the relay on fire wall with the supplied screw, Polaris offers 4 spots on the fire wall for this purpose.
Un-plug passenger side headlight and plug into our adapter then plug our
adapter into the headlight
Attach the wire with the fuse on it to the battery post on the factory
barrier strip, if you have not yet run power to that post then you need
to do so, the factory provided switched post only offers low power. XTC
offers a RZR Power Up cable system with Circuit Breaker # RZR-PWR-up2
and 4 Seat for this purpose.
Attach accessories power wire to the Orange wire with the supplied butt
connecter
Verify operation, Turn the key on and put headlight switch on high beam
and the accessory should turn on.
Note: The relay comes with a 20 AMP fuse and can be increased to a 30 AMP if needed or reduced. Install the fuse size that the accessory that is being powered calls out for. Always use what the Manufacture recommends.
For more details on installation go to www.xtcinstall.com.
We can also be reached by email at
support@xtcmotorsports.net
XTC Power Products
A Division of XTC Motorsports LLC
925 N McQueen RD. #101
Gilbert AZ 85233
480-558-8588
www.xtcpowerproducts.com
Copyright © 2015 XTC
MOTORSPORTS LLC, all rights reserved.